Flysky NB4+/NB4 Pro+ DragRacing FRM303 amplificateur de portée module amplificateur de puissance module amplificateur de distance montage amplificateur de signal

SoarSky SKU : SS-202604SID625
Version du module:
Couleur: Blue(Pre Order 20 day)
FRM303 Version:

Stock faible

Prix de vente $199.00 -100% Prix normal
Prix normal $199.00
Taxe inclu. Expédition calculée à la caisse.

Paiement sécurisé

Assistance technique

La plupart des commandes sont expédiées sous 48 heures

Shipping calculated at checkout. Shipping policy

Flysky NB4+/NB4 Pro+ DragRacing FRM303 amplificateur de portée module amplificateur de puissance module amplificateur de distance montage amplificateur de signal
Prix de vente $199.00 Prix normal
Prix normal $199.00
Frequently Asked Questions
FRM303 Module Mount User Manual

https://soarskyrc.com/blogs/technology-sharing/flysky-nb4-nb4-pro-dragracing-frm303-high-power-module-mount-installation-guide

Does the FRM303 Module Mount support charging?

Yes, it supports charging. It can charge 18650 batteries via the side Type-C interface. Charging takes approximately 4-5 hours, with a charging power of 5V-1.5A.

What does it mean when the red, blue, and green lights on the FRM303 tuner are flashing?

It indicates low battery. Please charge the 18650 battery.

What does it mean when the red light on the FRM303 tuner is flashing?

It's a warning of a signal input error. The FRM303 needs to be set to recognize PPM signals. Setting method: FRM303 supports switching between serial signals, PPM signals and S.BUS signals. The setting steps are as follows: 1. Push upwards the Up key for ≥ 3S and < 9S while powering on the RF module, it enters the input signal setting state. Now LED in blue is on. 2. Push upwards the Up key or push downwards the Down key to switch the input signal. LED flashing states vary with signals as shown in the table below. 3. Press the Center key for 3S to save the settings. Push the Left key to exit the signal setting state. Blue LED Color: One-flash-one-off represents the recognition input signal PPM

What's in the Box
  • 1x Cooling fan
  • 4x Fan mounting screws
  • 2x NB4 Pro+ Base side protective frames
  • 1x NB4 Pro+ Base front protective frame
  • 1x NB4 Pro+ Base rear protective frame
  • 4x NB4 Pro+ protective frame screws — Hex 2.0mm
  • 1x NB4 Pro+ Base front protective frame mount
  • 4x NB4 Pro+ Base front protective frame mount screws — Hex 1.5mm
  • 1x Signal conversion board bracket
  • 4x Signal conversion board bracket screws — Hex 2.0mm
  • 1x Signal conversion board fixing rod
  • 2x 18650 battery
  • 1x Signal conversion board
  • 1x FRM303 signal cable
  • 2x FRM303 mounting screws — Hex 1.0mm
  • 1x Type-C cable

Recommandations